Engineering · Unit 3 · QCAA sample IA2 All sample IA2 questions
QCAA sample IA2 · Section 1 · Multiple choice

Question 2

[1 mark]

Your teacher writes your IA2. This is the QCAA sample, so use it for the question shapes, and ask your teacher for practice that matches your school’s paper.

The question [1 mark]

The ultimate tensile strength (UTS) value is located on a stress–strain graph at the

Not quite. You have described the elastic limit or yield point, where the deformation begins to be permanent. The curve climbs to a higher stress after it.

Not quite. You have picked the fracture point, which for a ductile material is lower than the UTS.

That is it. Step through the hints below to see why.

Not quite. You have picked the elastic region, whose slope gives Young’s modulus. It is a part of the graph, not one stress value.

StressStrainSchematic, not to scalehighest stress on the curveelastic limit oryield pointpermanent stretch beginshighest stress on the curvefracture pointbreaks at the neckmaximum stressnecking happens after this pointeven stretch, about to neckhighest stress on the curveelastic regionslope = Young’s modulussprings back when unloaded

Test an option to see the place on the curve that it describes.

Black: the stress–strain curve for low-carbon steel. Orange: the place the tested option describes, with a dashed line across to the stress axis. Grey dotted: the highest stress the curve reaches.

This point is the elastic limit or yield point. The curve climbs to a higher stress after it, so it is not the highest stress.

This is the fracture point. For a ductile material the curve has already fallen by here, so the stress is lower than the UTS.

This is the top of the curve, reached just before the specimen begins to neck. The highest stress on the curve is the UTS, so this option matches.

This is the elastic region. Its slope gives Young’s modulus, and every stress on it is below the top of the curve.

Try the question first. Choose a hint above when you want one.

The UTS is the highest point on the curve. It is the largest stress the specimen takes during the test.

The highest point is reached just before the specimen begins to neck.

The maximum stress before necking is option (C).

Why?

After the UTS the specimen thins at one spot. The stress on the graph falls because it is still being calculated with the original area.

(A) describes the elastic limit or yield point. (B) is the fracture point, which for a ductile material is lower than the UTS. (D) is the elastic region, whose slope gives Young’s modulus.

The UTS is the highest point on the curve, reached just before the specimen begins to neck.

(C)

Only mark this done when you could do it without help. Reading the solution does not count.

Back to the index

Question wording is from the QCAA Engineering 2025 v1.4 IA2 sample assessment instrument, and the marker lines are from its sample marking scheme, © State of Queensland (QCAA) 2026, licensed under CC BY 4.0. Figures are redrawn. The solutions, animations and commentary are Tangent Tuition’s. Tangent Tuition is not affiliated with the QCAA.