Your teacher writes your IA2. This is the QCAA sample, so use it for the question shapes, and ask your teacher for practice that matches your school’s paper.
A 3.0 cm diameter steel rod has a 2.5 kN tensile force applied to its ends. What stress does the steel rod experience?
Not quite. No single slip gives this option. One that comes near its digits is dividing by the circumference in place of the area: $2500 \div (\pi \times 30) = 26.5$ N per mm. That is not a stress, and it is about ten times this option. Check that you divided the force by the area of the cross-section, $\pi r^2$.
That is it. Step through the hints below to see why.
Not quite. You left $\pi$ out of the area: $2500 \div 15^2 = 11.1$. The area of a circle is $\pi r^2$.
Not quite. You used the diameter in centimetres as if it were the radius in millimetres: $2500 \div (\pi \times 3^2) = 88.4$. Convert to 30 mm and halve it first.
Test an option to see the working that leads to it.
Grey disc: the real cross-section of the rod, drawn to scale. Orange hatching or orange dashed line: the part of it that the tested working divides the force by.
No single slip gives 2.7 MPa. Dividing by the circumference gives 26.5 N per mm of edge, which is not a stress and is about ten times this option. Stress needs the area of the cross-section.
With the radius as 15 mm the area is $706.9\ \text{mm}^2$ and the stress is 3.54 MPa, which rounds to 3.5 MPa. This option matches.
The square on the radius is $225\ \text{mm}^2$, which is $\pi$ times smaller than the circle. Leaving $\pi$ out makes the stress $\pi$ times too big.
A radius of 3 gives an area 25 times too small, so the stress is 25 times too big. The 3.0 is the diameter in centimetres: it is 30 mm, so the radius is 15 mm.
Try the question first. Choose a hint above when you want one.
The diameter is 3.0 cm, which is 30 mm, so the radius is 15 mm. The force is 2.5 kN, which is 2500 N.
Newtons divided by square millimetres gives megapascals, so the answer comes out in the unit the options use.
Stress is the force divided by the area of the cross-section, and the cross-section is a circle.
$$\sigma=\frac{F}{A}=\frac{2500}{\pi\times15^2}=3.54\ \text{MPa}\approx3.5\ \text{MPa}$$
This is option (B).
The diameter is 3.0 cm, which is 30 mm, so the radius is 15 mm, and the force is 2500 N.
$$\sigma=\frac{2500}{\pi\times15^2}=3.54\ \text{MPa}\approx3.5\ \text{MPa}$$
Only mark this done when you could do it without help. Reading the solution does not count.
Question wording is from the QCAA Engineering 2025 v1.4 IA2 sample assessment instrument, and the marker lines are from its sample marking scheme, © State of Queensland (QCAA) 2026, licensed under CC BY 4.0. Figures are redrawn. The solutions, animations and commentary are Tangent Tuition’s. Tangent Tuition is not affiliated with the QCAA.
Spot a mistake on this page? Report it