Your teacher writes your IA2. This is the QCAA sample, so use it for the question shapes, and ask your teacher for practice that matches your school’s paper.
A stress-strain diagram is shown.
Identify which mechanical property is best represented by the stress–strain graph.
Not quite. Hardness is resistance to scratching and indentation, and a tensile test does not measure it. A stress–strain graph cannot show that a material is hard.
Not quite. A tough material would show a long curve after yielding. This line stops with no plastic section.
That is it. Step through the hints below to see why.
Not quite. A ductile material would show a long curve after yielding. This line is nearly straight from the origin to rupture.
Black line: my redraw of the line printed in the question. Everything else is a comparison I have added for the option you are testing. Grey dashed curve: the general shape a ductile or tough material would give. Blue dotted section: its plastic section. Blue hatching: the energy it absorbs. Orange dashed line: a ruler laid beside the printed line. The comparison shapes are sketches, not data. The printed axes have no scale, so compare the shapes and not the sizes.
Nothing is being tested yet. Choose Test (A), (B), (C) or (D) above.
Hardness is resistance to scratching and indentation. A tensile test does not measure it, so nothing on a stress–strain graph can show that a material is hard.
A tough material absorbs a lot of energy before it breaks, and that needs a long curve after yield, like the hatched shape. The printed line stops with no plastic section.
The printed line is nearly straight from the origin to rupture. There is no yield, no long plastic section and no necking. The material deforms elastically and then breaks.
A ductile material stretches a long way after it yields, like the blue dotted section of the comparison curve. The printed line has no such section.
Try the question first. Choose a hint above when you want one.
The sample prints strain on the vertical axis and stress on the horizontal axis, which is the reverse of the usual way round. Always read the axis labels before you read the line.
The reading is the same either way, because the feature that matters is whether there is a plastic region.
The line is nearly straight from the origin to rupture. There is no yield, no long plastic section and no necking.
A ductile or tough material would show a long curve after yielding.
The material deforms elastically and then breaks. That is brittle behaviour, option (C).
Hardness is resistance to scratching and indentation, and a tensile test does not measure it.
The line is nearly straight from the origin to rupture, with no yield, no long plastic section and no necking. The material deforms elastically and then breaks, which is brittle behaviour.
Only mark this done when you could do it without help. Reading the solution does not count.
Question wording is from the QCAA Engineering 2025 v1.4 IA2 sample assessment instrument, and the marker lines are from its sample marking scheme, © State of Queensland (QCAA) 2026, licensed under CC BY 4.0. Figures are redrawn. The solutions, animations and commentary are Tangent Tuition’s. Tangent Tuition is not affiliated with the QCAA.
Spot a mistake on this page? Report it